• EN
  • 登录
访问量:   最后更新时间:--

陶于兵

博士生导师
硕士生导师
职称:教授
教师姓名:陶于兵
电子邮箱:
学历:硕博连读
性别:男
学位:博士
在职信息:在职
毕业院校:西安交通大学
所属院系:能源与动力工程学院
学科:动力工程及工程热物理
论文成果
当前位置: 中文主页 > 科学研究 > 论文成果
Numerical study on coupling phase change heat transfer performance of solar dish collector
发布时间:2025-04-30    点击次数:

发布时间:2025-04-30

论文名称:Numerical study on coupling phase change heat transfer performance of solar dish collector

发表刊物:SOLAR ENERGY

摘要:In solar dish collector system, the heat transfer process is a typical coupling heat transfer problem, where the heat conduction, radiation heat transfer, convection heat transfer and phase change heat transfer are coexisting. In the present paper, a coupling model for Monte Carlo Ray Trace Method (MCRTM) and Finite Volume Method (FVM) was established to study the coupling heat transfer problem. Firstly, based on MCRTM, the non-uniform 3D heat flux distributions on the solar dish receiver inner surface were obtained. Then the non-uniform heat flux distribution is used as the boundary condition to simulate the phase change and convection heat transfer process inside the heat transfer tube. The effects of the non-uniform heat flux distribution on temperature field in phase change material (PCM) were examined. The results show that the non-uniform heat flux on the tube surface will result in seriously non-uniform temperature distribution in PCM. Then the optimization analyses for the temperature distribution were performed according to the convection heat transfer process and heat conduction process respectively. The results show that in the studied conditions, when heat transfer fluid (HTF) velocity increases from 10 m/s to 25 m/s, the maximum temperature difference in PCM will decrease from 781.2 K to 497.8 K, which reduces about 36.3%. However, it will cause the heat storage capacity and HTF outlet temperature decrease. When the thermal conductivity increases from 3.8 W m(-1) K-1 to 19.0 W m(-1) K-1, the maximum temperature difference will decrease from 781.2 K to 409.5 K, which reduces about 47.6%. And it will not result in HTF outlet temperature and heat storage capacity decreasing. So, enhancing the PCM thermal conductivity is an efficient method to achieve more uniform temperature distribution in PCM.

合写作者:Tao, Y. B.; He, Y. L.; Cui, F. Q.; Lin C.H.

卷号:90

页面范围:84-93

是否译文:

发表时间:2013-04-01