Hydrotreating the distillate fraction of algal biocrude with used engine oil over Pt/C for production of liquid fuel
发布时间：2025-04-30
点击次数：
- 发布时间：
- 2025-04-30
- 论文名称：
- Hydrotreating the distillate fraction of algal biocrude with used engine oil over Pt/C for production of liquid fuel
- 发表刊物：
- Catalysis Today, 2019, in press
- 摘要：
- Hydrothermal liquefaction of Auxenochlorella pyrenoidosa (AuP) and Arthrospira platensis (ArP) at 350 °C for 1 h produced algal biocrudes (BCs), BC(AuP) and BC(ArP), with yields of 41.82 and 36.60 wt.%, respectively. These two algal BCs were cut into five distillate fractions (DFs) of 25-100 °C (DF0), 101-200 °C (DF1), 201-300 °C (DF2), 301-400 °C (DF3), and ≥401°C (DR) using atmospheric distillation under N2 atmosphere. The total yields of DF1, DF2, and DF3 from either BC(AuP) or BC(ArP) are at least 60 wt.%. All the DFs, from either AuP or ArP, showed different yields and elemental and molecular compositions. Next, the DF1, DF2, and DF3 DFs were each blended with used engine oil (UEO) at a mass ratio of 1:1 and treated at 400 °C for 4 h with an additional 0.1 kgPt/C/kgfeed under 4 MPa H2. The presence of UEO could dilute the DF, avoid solvent extraction of the product oil, favor desulfurization of the upgraded oil, and be directly recovered as a major part of the product oil. Catalytic hydrotreatment of the DF and UEO blends led to a higher upgraded oil yield (>79 wt.%) and lower coke (<12 wt.%) and gas (<9 wt.%) yields compared with those from the BCs alone under the same process conditions, and higher upgraded oil yields were achieved when using the DFs with high boiling point ranges. The upgraded oil had a lower total acid number and oxygen, nitrogen, and sulfur contents than those of the BC. The sulfur contents of the upgraded oil produced from the DF and UEO blends were much lower than those from the BCs alone, and the lowest sulfur content of 12 ppm (w/v) was achieved. The high abundance of unsaturated hydrocarbons and nitrogen- and oxygen-containing compounds in the BC were replaced by a high abundance of hydrocarbons and benzene derivatives in the upgraded oil. The heating value of the upgraded oil (~48 MJ/kg) was higher than that of the BC. The main gas-phase products were H2, CH4, C2H6, and C3H8. Overall, many of the properties of the upgraded oils obtained from the catalytic hydrotreatment of the DF and UEO blends were similar to those of hydrocarbon fuels derived from fossil fuel resources.
- 合写作者：
- Long-Fei Xie, Yu-Ping Xu, Xian-Lei Shi*, Feng Wang, Pei-Gao Duan*
- 卷号：
- in presss
- 是否译文：
- 否
- 发表时间：
- 2019-03-17