Contact mechanics of modular metal-on-polyethylene total hip replacement under adverse edge loading conditions
点击次数：
发布时间：2025-04-30
发布时间：2025-04-30
论文名称：Contact mechanics of modular metal-on-polyethylene total hip replacement under adverse edge loading conditions
发表刊物：Journal of Biomechanics
摘要：Edge loading can negatively impact the biomechanics and long-term performance of hip replacements. Although edge loading has been widely investigated for hard-on-hard articulations, limited work has been conducted for hard-on-soft combinations. The aim of the present study was to investigate edge loading and its effect on the contact mechanics of a modular metal-on polyethylene (MoP) total hip replacement (THR). A three-dimensionalfinite element model was developed based on a modular MoP bearing. Different cup inclination angles and head lateral microseparation were modelled and their effect on the contact mechanics of the modular MoP hip replacement were examined. The results showed that lateral microseparation caused loading of the head on the rim of the cup, which produced substantial increases in the maximum von Mises stress in the polyethylene liner and the maximum contact pressure on both the articulating surface and backside surface of the liner. Plastic deformation of the liner was observed under both standard conditions and microseparation conditions, however, the maximum equivalent plastic strain in the liner under microseparation conditions of 2000mm was predicted to be approximately six times that under standard conditions. The study has indicated that correct positioning
the components to avoid edge loading is likely to be important clinically even for hard-on-soft bearings for THR.
合写作者：Xijin Hua, Junyan Li, Ling Wang, Zhongmin Jin
是否译文：否
发表时间：2014-01-01